 |
|
|
|
|
|
  |
|||
|
|
||||||||
| PROCESS |
MATERIAL | APPLICATION | BASE |
CLEANCUT |
| All machining processes |
non-ferrous metals, low-alloy steels |
circulating lubrication system | water soluble, contains mineral oil | 623 FREE-CUT |
| Difficult machining processes such as deep drilling, machining cylinder boring |
all commonly used iron and steel materials |
circulating lubrication system | water soluble, contains mineral oil | 626 EASY-CUT |
| All machining processes particularly reaming | specially for aluminium, even with < 1% Si content, for excellent surfaces results | circulating lubrication system | water soluble, contains mineral oil | 628 SOFT-CUT |
| Grinding and all commonly used machining processes |
all commonly used materials such as steel materials including hardened steels, tempered steels |
circulating lubrication system | water soluble, 100 % synthetic | 641 GRIND-CUT |
| Machining, grinding, forming | all commonly used materials such as steel, hardened steels |
circulating lubrication system | water soluble, 100 % synthetic | 645 EXTRA-CUT |
| Machining, grinding, forming | all commonly used cast iron materials and steels tempered steels |
circulating lubrication system | water soluble, 100 % synthetic | 646 SUPRA-CUT |
| Machining of all materials at slow speeds |
all commonly used materials, including stainless, heat-resistant steels |
manual lubrication, spray can | non-water soluble, mineral oil based |
606 OIL-CUT |
| Machining of all materials at slow speeds, forming |
aluminium and non-ferrous metals | manual lubrication, spray can | non-water soluble, mineral oil based | 603 WHITE-CUT |
| For emulsion preparation and killing of germs in existing circulation systems |
add into the sump 8 hours before CLEANCUT change |
alkaline, water soluble, biocide concentrate |
685 SYS-CLEAN |
|
| Prevention of foam formation in very soft water or at very high cutting speeds |
add to foaming emulsion products as described in the instructions |
silicone free defoaming concentrate |
662 FOAM-EX |
|
| Prevents biofouling of the made-up cooling/cutting lubricant | use within the made-up cooling/cutting lubricant as described in the instructions | semi acetale/isothiozolinone mixture | 654 BIO-AD1 |
|
| Prevents biofouling of the made-up cooling/cutting lubricant |
use within the made-up cooling/cutting lubricant as described in the instructions |
hexahydrotriazine with S-hetero-cycle |
656 BIO-ADX |
|
| Dip bath for chemical drying of components |
immerse components in the bath and leave to drip dry |
aromatic compound free, alkaline resistant, low odour base |
677 RUST-FLUSH |
|
| Reconditioner for 677 RUST-FLUSH |
activates contaminated 677 in dip-tanks |
676 RF-CONDITIONER |
||
| Passivating and drying of metalsurface |
dip workpieces in tank fill systems |
water mixable, carbohydrates | 671 RUST-RINSE |
|
| Surface cleaning of all tooling machines and components |
apply by means of brush or hand spray can |
alkaline cleaning concentrate | 681 SURF-CLEAN |
| The DEPAC product selection guide is intended only for general recommendations. Of course there are also many other applications for each individual product. If you feel unsure about the selection, our application engineering specialists will be pleased to assist you. |
